|
"Consistent, Controlled Installation"
Our Snap It Sr Tube Plugs are proven with rated holding pressures up to 7,000 psid. When properly installed, these plugs remove all the guess work of installation.
No welding, No tube sheet damage, No Leaks, No worry. Use our complete line of plugging equipment to properly install.
Tube Plugging has never been easier; simply brush the tube end to prepare the surface, insert the plug and
“Snap It” in place, the entire procedure takes less than 1 minute per tube.
Features and Benefits:
• All Tooling is fully compatible with Competitors’ systems
Safety:
• High Safety factor without blowout pressures exceeding 28,000 PSIG (dependent on the tube size)
• Requires no welding, thus eliminating sparks or open flames
• Design greatly reduces the chance of plugs turning into dangerous projectiles, especially during removal
Savings, Time & Expense:
• Ease and quickness of installation time per plug is only a few minutes resulting in a
labor cost savings of up to 80+% while greatly reducing downtime
• Eliminates the possibility of damage to tube sheets and tube sheet ligaments from welding or overdriving a tapered pin
• Guaranteed to provide a Leak Free Helium seal to 1 x 10-9 c/sec
• Ideally suited to plug Fin Fan Headers quickly & reliably
• Cost of installation and removal equipment is inexpensive and can be Purchased or Rented
|
