EZ Vent® Slip Blind

Yes, multiple ports can easily be added, and we can add them on both sides upon request! Please specify how many and whether you want them on the upstream or downstream side of the blinds on your quote request.

Sometimes. For every NPT or Socketweld blind, there is a minimum thickness required, which is also determined by whether or not the blind needs to be rated for pressure. We can easily make your blind thicker to meet custom needs.

No, since the smallest tap size is 1/8" NPT or SW (which would require a .410 hole) it would need to be a minimum of 1/2" thick.

No. Our internal standard is to place the port at approximately 180 degrees from the handle with no interference between the connection and the bolts. However, if you need the connection point in a different location on the blind, we can manufacture it to your specs.

When requesting an alternate port placement, we recommend that you specify where in relation to the handle you would like the port(s) to be located (ie. approximately 90 Degrees from handle) and note that the vent must be located between bolt holes.

Yes! We can completely customize blind thicknesses to your needs.

Our EZ Vent blinds are easily identified by the "V" notch that we place in the top of the handle.

We always identify the vented side of the EZ Vent blind for you by marking it "EZ VENT," "EZVB," or "VENT" on the handle. Regardless, the vented side will always be the side with text markings. If you would like us to mark it in some other fashion for your needs that's EZ!

They are available for either rental or purchase, depending on your needs. Some restrictions apply.

Yes, just let us know your requirements. We can completely customize our products to your needs, and we regularly finish our blinds with a Machined 125-250 rms finish or an RTJ (RJ) for the gasket area.

Absolutely. We manufacture our EZ Vent Blinds and Spectacle blinds in house, and we're happy to put a port in a spectacle blind of any size or rating.